Diamond Bit Touch, tornado 021, red

Diamond burr, red, tornado shape 021 from Touch

The "tornado" diamond burr 021 with a red marking (soft abrasive) is designed for delicate hardware/combination machining. The spiral cut ("tornado") speeds up the process and reduces heat, allowing you to gently lift the cuticle, cleanly process the lateral folds, and softly mattify the nail plate as an alternative to a buff.

Features of the Touch Diamond Cutter

• Soft abrasiveness (red): gentle work on thin and standard cuticles.
• Spiral "tornado" geometry: removes the cuticle faster and reduces clogging, improving tool control.
• Diameter 0.21: precise work in the pocket and along the folds with minimal trauma.
• Smooth stroke: stable processing at low and medium pressures. RPM with light pressure.
• Wear resistance: The "cool-touch" diamond coating is designed for long-term use (approximately 3-8 months).

How to use the Touch diamond burr

• Install the burr into the handle of the device and securely fix it.
• Work at low-medium speeds, maintaining a minimum angle and light pressure.
• Lift the cuticle, clean/align the side ridges; if necessary, softly mattify the plate.
• Monitor the heating and move the tool constantly; Upon completion, thoroughly clean and recondition the cutter.

Abrasiveness: Red - Soft
Shape/Size: Tornado, Ø021 (spiral notch)
Material: Highly wear-resistant diamond coating (approximately 3-8 months with proper use)